[ROBOT]
ROBT_COM=COM2
ONE_ROBOT_MODE=1	// Enable or Disable Serial Robot (1:Enable  0:Disable)
MON_FAIL_SIGNAL=0	// Send Fail Signal(0xEC) in Monitoring Mode (1:Enable  0:Disable)
SHOW_INSTRUMENT_SERVER=1  

// HHPP_COM -> Serial
// MSTS_COM & DCPS -> GPIB
// 1번부터 차례대로 설정 

[PHONE01]
HHPP_COM=1
GPIB_BDNO=0
MSTS_COM=14
DCPS_COM=5


[PHONE02]
HHPP_COM=
GPIB_BDNO=0
MSTS_COM=15
DCPS_COM=6


[PHONE03]
HHPP_COM=
GPIB_BDNO=
MSTS_COM=
DCPS_COM=


[PHONE04]
HHPP_COM=
GPIB_BDNO=
MSTS_COM=
DCPS_COM=


//+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
//	아래 부분은 DTMS (자동배포시스템) 일 때만 사용되는 파라메터입니다.
//+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

[PARAMETERS] // DTMS Parameters
HW_VERSION =MP 1.000
WORK_POSITION = 1	// 0 : Batt	1 : RF
POLAR_CAL_LOG = 0	// Polar, RSB, CS Cal Log Print Option
SLEEP_CURRENT = 0	// 0 : Sleep Current Test
QUALCOMM_USB = 0	// 0 : UART	1 : QUALCOMM USB
CAL_N_FINAL = 0		// 0 : Disable	1 : Cal & Final Test for Cell Line
MON_WORK_CNT = 20	// 0 : Real Cal	1 ~ 100 : Monitoring Count(모니터링 횟수)
MON_FAIL_CNT = 3	// allowed Fail Counts in Monitoring mode(최대 불량 횟수)
RTX_SWEEP_CAL = 0	// 0 : Normal Cal	1 : RTX Sweep Cal(Not applied)
TOTAL_TEST_CNT = 50	// Equipment Warning Message Display options(총 시험 횟수 몇 회 이상이고)
TOTAL_FAIL_RATES = 20	// Equipment Warning Message Display options(불량율 몇 % 이상이면 표시)
END_BAND = EGSM		
// NONE, AUTO, EGSM, PCS, WCDMA, WCDMA_1900, WCDMA_850, WCDMA_BC4

FTM_DELAY_ON = 0	// Delay Time Before enter FTM (FTM 진입 전 Delay Time 사용)
FTM_DELAY_TIME = 0	// Wanted Delay Time (sec)
//+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
